История
16 мая 2019
Нет описания правки
+9
Новая страница: «# Find the GPIO number corresponding to the desired terminal in the tableWB2.8/WB3.5/Wiren Board 4: Сп…»
−380
Новая страница: «See GPIO.»
−10
Новая страница: «==The example of work in Linux==»
−6
Новая страница: «You can also easily connect a ready relay module, [http://dx.com/p/4-channel-5v-relay-module-black-blue-171144 such as]»
−62
Новая страница: «The illustrations show the wiring diagrams of the led and relay.»
−52
Новая страница: «The load is connected as follows: "plus" load is connected to the power supply, "minus" is connected to the transistor output. For the load to start working, you…»
−187
Новая страница: «thumb|400px|Led connection example thumb|400px|Relay connection example»
−54
Новая страница: «==The examples of use==»
−22
Новая страница: «'''Note for Wiren Board versions 2.8 and 3.5:''' * when connecting inductive loads (relay) do not forget to put a protective diode - a surge of voltage from the r…»
−385
Новая страница: «thumb|400px|Equivalent Ax output circuit for WB4 controller To reduce the total number of terminals, the low-voltage load control channels are com…»
−293
Новая страница: «==Technical detail==»
−19
Новая страница: «All transistor outputs can be controlled from the web interface, where they are called according to the terminal…»
−104
Новая страница: «There are the so-called "transistor outputs", also FET, to control the low-voltage load (with voltage up to the input voltage) in the Wiren Board controllers. The…»
−244
Новая страница: «Low voltage load control»
+4848