История
22 апреля 2021
27 июня 2019
Новая страница: «For operation, you must disable hardware flow control. Additional port configuration as RS-485 is not required.»
−104
Новая страница: «* ''/dev/ttyMOD1'' - when installed in the first slot for extension module (MOD1) * ''/dev/ttyMOD2'' - when installed in the second slot for extension module (MOD2)»
−45
Новая страница: «The port is available in the system as»
−12
Новая страница: «== Operation ==»
−3
Новая страница: «The device is detected immediately, no reboot is required.»
−54
Новая страница: «==Configuration== Configuration is done in the web interface. Section Configs => Hardware Modules Configuration. Next, in Internal slot 1 or in Internal slot 2, s…»
−85
Новая страница: «{| class="wikitable" !Terminal !Function |- |O1 |A (D+) |- |O2 |B (D-) |- |O3 |Isolated GND (Common, C) |}»
−10
Новая страница: «RS485 signals are output to the terminals of the O1-O3 extension module.»
−24
Новая страница: «<div class="tright" style="clear:none">thumb|200px| WBE2-I-RS485-ISO reverse side </div> <div class="tright" style="clear:none"…»
−61
Новая страница: «== Pinout ==»
−14
Новая страница: «Module contains 120 Ohm terminator between lines A and B. To enable it, close the jumper between termination contacts on the top edge of the board.»
−125
Новая страница: «Module with galvanically isolated RS-485 interface. Insulation voltage: 1.5 kV. Speed up to 1 Mbit/s.»
−78
Новая страница: «Wiren Board 6: RS485-ISO extension module (WBE2-I-RS485-ISO)»
+1960