История
31 марта 2023
27 июня 2019
Нет описания правки
−70
Обновление для соответствия новой версии исходной страницы.
+40
Нет описания правки
−39
31 мая 2019
Новая страница: «The modem supports multiplexing mode which creates virtual ports,you can simultaneously work with the modem via these ports. For example, one port can be used to…»
−266
Новая страница: «===Multiplexing ports===»
−20
Новая страница: «* Get module IMEI-code (xxxxxx is a unique number <pre> AT+GSN 86820400xxxxxxY»
+3
Новая страница: «* Request time from the built-in real-time clock (RTC) module <pre> AT+CCLK? AT+CCLK="14/03/19,01:20:29+00" </pre>»
−61
Новая страница: «* To synchronize the speed of the port (not a real command) <pre> AAAAAAAAAAAAAT </pre> * All networks list <pre> AT+COPS=? </pre> * Signal strength (see [http…»
−142
Новая страница: «(some commands may vary for some modules, see the module documentation for details)»
−100
Новая страница: «==== Command examples ====»
−11
Новая страница: «* Go to settings (press ''Ctrl+A'', then ''O''), select ''Serial port setup'', set port ''/dev/ttyGSM'',set speed and parity - ''115200, 8N1'', ''Hardware flow co…»
−390
Новая страница: «For interactive mode: *run '''minicom''' with the following key that creats the job profile to the port (transmission speed, parity, etc.): <pre> $ minicom -s /d…»
−133
Новая страница: «Read the instructions - Working with a serial port from Linux. Note the settings:…»
−120
Новая страница: «=== Low-level work with the module via AT-commands===»
−43
Новая страница: «As an example, we specify two instructions for the organization of such a mode of operation: # http://lstein.github.io/Net-ISP-Balance/ # https://serverfault.com/…»
−51
Новая страница: «If the controller is normally connected to the Internet via Ethernet or Wi-Fi, and GPRS is to be used only in case of a main channel failure, this mode of operati…»
−412
Новая страница: «For more complex cases where the physical connection on the eth0 interface is not lost, it is recommended to use scripts (based on the availability of any network…»
−301
Новая страница: «In this case, if the connection via eth0 is lost (cable disconnection, switch disconnection, etc.), the route via the ppp0 interface becomes the default route.»
−133
Новая страница: «and for the interface — metric 100: auto ppp0 iface ppp0 inet ppp ## select provider: megafon, mts or beeline below provider mts metric 100…»
−17
Новая страница: «The easiest way to ensure fault tolerance is to specify two default routes with different metrics, for example: for eth0 interface, specify metric 10: auto et…»
−139
Новая страница: «==== Using GPRS as a backup channel ====»
−55
Новая страница: «Note that when you deinitialize the ppp0 interface, all created associated with this interface routes will be automatically deleted.»
−101
Новая страница: «As a supplementary measure to improve reliability in the presence of two connections, we can offer the use of DNS servers that are independent of the provider, fo…»
−244
Новая страница: «DNS server addresses are replaced with those that were received from the mobile provider. If you are using DHCP on the ethernet interfaces and the interface ppp0,…»
−219
Новая страница: «'''Important!''' By default, the ppp0 interface '''does not add a new default route via ppp during initialization''', if such a route exists and is configured, fo…»
−573
Новая страница: «====DNS and routing settings====»
−28
Новая страница: «For ppp-interfaces, there are directories, executable files from which are also run at different phases of connection establishment. But, if, for example, etherne…»
−378
Новая страница: «auto ppp0 iface ppp0 inet ppp provider mts #restart modem if it's broken or frozen pre-up wb-gsm restart_if_broken #Then wait for it to load and find the networ…»
−54
Новая страница: « As an example, we will give here the parameters that '''we recommend''' to use when setting up a ppp connection with mobile Internet providers. <syntaxhighlight…»
−140
Новая страница: «In the /etc/network/interfaces file, you can use the standard iface pre-up, up, post-up, down, pre-down, post-down options to configure ppp. They define the comma…»
−183
Новая страница: «The usage of the ppp0 interface configuration in ''/etc/network/interfaces'' file gives the most comprehensive ability to control establishing the connection to t…»
−221
Новая страница: «For connection to restart itself when it breaks, and to execute it an unlimited number of times, add the following lines to the connection settings (the settings…»
−188
Новая страница: «After creating the configuration file, start the connection by running <syntaxhighlight lang="bash"> pon connection name </syntaxhighlight> or by editing ''/etc/n…»
−132
Нет описания правки
−8
Новая страница: «If you connect to the Internet via 3G, you should replace the UART port (/dev/ttyGSM (or /dev/ttyAPP0 in older controller models)) with the CDC-ACM port (/dev/tty…»
−242
Новая страница: «Access to the Internet via GPRS is provided via PPP using the [https://linux.die.net/man/8/pppd pppd] service. For its operation, you need to create a configurati…»
−730
Новая страница: «==== Full instruction ====»
−17
Новая страница: «*Connect the antenna to the GSM connector *Insert SIM card into micro-SIM slot 1 *Turn on the modem executing wb-gsm restart_if_broken *If your controller is equ…»
−414
Новая страница: «==== Step-by-step instructions for setting up a permanent GPRS connection ====»
−41
Новая страница: «In the standard software set of the Wiren Board controller connection settings in ppp protocol for MTS, MegaFon and Beeline mobile operators are included. If yo…»
−446
Новая страница: «==== Quick setup of automatic Internet access ====»
−57
Новая страница: «The modem must be turned on before you can access the Internet. To do this manually or in the network interface configuration file (see below), run the following…»
−107
Новая страница: «===Internet connection===»
−11
Новая страница: «SMS and USSD in Russian in ''gammu'' still do not work always properly, so commands can be useful to switch the language of USSD and transcoding incoming and ou…»
−275
Нет описания правки
+23
Новая страница: «====SMS and USSD in russian(if needed)====»
+3
Новая страница: «#Create a configuration file by running ''gammu-config'' ##In the ''Port'' parameter, specify ''/dev/ttyGSM'' ##In the ''Connection'' parameter, specify''at115200…»
−174
Новая страница: «(here is a brief instruction below, see the full documentation on the project website)»
−81
Новая страница: «300px|thumb|right|''gammu-config'' The easiest way to work with SMS is with the help of [http://wammu.eu/gammu/ ''Gammu''] program (t…»
−46