translator, wb_editors
4390
правок
Matveevrj (обсуждение | вклад) |
Matveevrj (обсуждение | вклад) |
||
Строка 1: | Строка 1: | ||
Before | Before you start | ||
#Be sure to | #Be sure to install a microSD card with the software image (included) into the device. | ||
#Install a | #Install a Micro-sized SIM card (if you plan to use the GSM module). | ||
#Check the switch | #Check the position of the switch.! N!#Connect the power supply. | ||
#Connect the power supply. | |||
=== microSD card === | === microSD card === | ||
Installed in the | Installed in the memory card slot ('''top''') with the contacts '''up'''. | ||
=== Micro-SIM card === | = == Micro-SIM card === | ||
Installed in the Micro-SIM card slot ('''bottom''') with the contacts '''down''' with the cut corner inward. | |||
=== Switch position === | === Switch position = == | ||
The pressed side with a dot is 'off'. | The pressed side with a dot is '''off'''. | ||
=== Power supply === | === Power supply === | ||
There are three types: standard, DIN | There are three types: standard, DIN rail, PoE injector. | ||
'''Do not connect two different power supplies at the same time''', | '''Do not connect two different power supplies at the same time''', this will burn them and the controller. | ||
The standard power supply is connected to the | The standard power supply is connected to the corresponding connector. | ||
The power supply | The DIN rail power supply is connected with wires to the large terminal blocks Vin and Gnd (next to with a relay, see the [diagram http://wirenboard.com/wiki/index.php/ %D0% A4 %D0% B0 %D0% B9 %D0% BB:WB3.5.png]) | ||
Passive PoE power supply is connected Ethernet cable. |