Translations:Первое включение Wiren Board Smart Home/3/en

Before you start

  1. Be sure to install a microSD card with the software image (included) into the device.
  2. Install a Micro-sized SIM card (if you plan to use the GSM module).
  3. Check the position of the switch.! N!#Connect the power supply.

microSD card

Installed in the memory card slot (top) with the contacts up.

Micro-SIM card

Installed in the Micro-SIM card slot (bottom) with the contacts down with the cut corner inward.

Switch position

The pressed side with a dot is off. Power supply There are three types: standard, DIN rail, PoE injector. 

Do not connect two different power supplies at the same time, this will burn them and the controller.

The standard power supply is connected to the corresponding connector. The DIN rail power supply is connected with wires to the large terminal blocks Vin and Gnd (next to with a relay, see the diagram) Passive PoE power supply is connected Ethernet cable.

Источник — https://wirenboard.com/wiki/index.php?title=Translations:Первое_включение_Wiren_Board_Smart_Home/3/en&oldid=77699