16 578
правок
(Новая страница: «See also: * ADC channels in Wiren Board 6.2 * ADC lists for older controller versions») |
|||
Строка 5: | Строка 5: | ||
#Voltage must be within acceptable range. | #Voltage must be within acceptable range. | ||
#Ax terminal blocks perform two functions: ADC and low voltage load control. Before measuring voltage, set the corresponding low voltage load control output to the "off" position. For example, if you are connecting to terminal A1, disable A1_OUT in the web interface (section Relays & FETs). | #Ax terminal blocks perform two functions: ADC and low voltage load control. Before measuring voltage, set the corresponding low voltage load control output to the "off" position. For example, if you are connecting to terminal A1, disable A1_OUT in the web interface (section Relays & FETs). | ||
#Connect your source to the terminal. The voltage value will immediately appear in the [[ | #Connect your source to the terminal. The voltage value will immediately appear in the [[Special:MyLanguage/Wiren_Board_Web_Interface | web interface]] on the ADCs. The value is also translated into the [[Special:MyLanguage/MQTT|MQTT]] message system. | ||
Also, the value can be obtained in manual mode: [[Special:MyLanguage/Low-level work with ADC|Low-level work with ADC]]. | Also, the value can be obtained in manual mode: [[Special:MyLanguage/Low-level work with ADC|Low-level work with ADC]]. |