Translations:WB Debug Console/6/en: различия между версиями
Fizikdaos (обсуждение | вклад) |
FuzzyBot (обсуждение | вклад) м (FuzzyBot переименовал страницу Translations:Отладочный порт/6/en в Translations:WB Debug Console/6/en без оставления перенаправления: Часть переводимой страни…) |
||
(не показаны 2 промежуточные версии 2 участников) | |||
Строка 5: | Строка 5: | ||
## TX to RX | ## TX to RX | ||
## RX to the TX | ## RX to the TX | ||
#: <I> (note: some adapters confused labeling - in this case, try to connect the TX to the TX and RX to RX) </ i> | #: <I> (note: some adapters confused labeling - in this case, try to connect the TX to the TX and RX to RX) </i> |
Текущая версия на 14:07, 3 ноября 2018
Debug port on the controller placed into three-pin: GND, RX and TX. To connect:
- Insert the USB-UART Adapter into your computer.
- Plug the connector pins to the pins of the adapter according to the scheme:
- GND to GND
- TX to RX
- RX to the TX
- (note: some adapters confused labeling - in this case, try to connect the TX to the TX and RX to RX)