12 063
правки
(Новая страница: «The WBMZ battery module comes complete with the top cover of the case on which the switch is mounted. The cover is installed instead of the included controller. T…») |
(Новая страница: «When assembling the controller with the module installed, pay attention to the wires of the module: they should not be between the indicator and the plastic light…») |
||
(не показано 5 промежуточных версий этого же участника) | |||
Строка 117: | Строка 117: | ||
The WBMZ battery module comes complete with the top cover of the case on which the switch is mounted. The cover is installed instead of the included controller. The old cover is removed with a screwdriver inserted into the side slots between the cover and the top of the housing. | The WBMZ battery module comes complete with the top cover of the case on which the switch is mounted. The cover is installed instead of the included controller. The old cover is removed with a screwdriver inserted into the side slots between the cover and the top of the housing. | ||
One battery contact is disconnected from the module to prevent discharge during storage. Before installation it is necessary to fix the disconnected contact in a screw clip of the module (it is shown in drawing by arrows). | |||
For the convenience of installing the jumper module in the upper part of the body can be removed (for example, wire cutters). | |||
[[File:Battery latches.png|300px|thumb|center| | [[File:Battery latches.png|300px|thumb|center|Module mounting]] | ||
The module Board is mounted on two latches (indicated in the figure), the battery down to the side of the Board. The battery should be located on the side of the side power module opening (shown by arrow). Do not apply pressure to the battery during installation — this may cause an internal short circuit and fire! | |||
After installing the module, connect the connectors to the Board, as shown by the arrows in the figure "controller Board with battery and switch connectors": red arrow — switch connector, blue — module connector. | |||
When assembling the controller with the module installed, pay attention to the wires of the module: they should not be between the indicator and the plastic light guide of the upper cover of the controller body. Removal of the module is made in the reverse order. |
правки