|
|
(не показано 9 промежуточных версий 3 участников) |
Строка 1: |
Строка 1: |
| ==Connecting to the debug port of new Wirenboard controllers (since 5.8 revision)== | | == Connection to the debug port of the controllers (For WB 6, 5.9 and 5.8) == |
| [[File:USBA-MICROUSBB.png|250px|thumb|right|USB — Micro-USB cable]] | | [[File:Debugusb58.png|250px|thumb|right| "Debug Console" connector in Wiren Board 5.8 and 5.9]] |
| You will need a standard USB (A) — Micro-USB (B) cable to connect the console port to your PC. Please attach the USB (A) plug to the PC and the Micro-USB (B) to your Wirenboard controller. [[Файл:Debugusb58.png|250px|thumb|right|'''Debug USB''' socket]]
| | [[File:WirenBoard6DebugConsole.png|250px|thumb|right|Debug Console connector Wiren Board 6]] |
| You can see the Debug Console writing under the appropriate debug socket.
| | [[File:USBA-MICROUSBB.png|250px|thumb|right|USB — Micro-USB Cable]] |
| New Wirenboard controllers use USB-Serial CH340/CH341 serial-to-USB adapter. Linux should automatically detect these chips^ see the output of the <code>dmesg</code> command after connection: the following line should appear in the end of the output: <code>usb 1-1: ch341-uart converter now attached to ttyUSB0</code>.
| | [[File:SerialUART_Win.png|250px|thumb|right|Windows port Number]] |
| The number of the ttyUSB may vary upon the number of devices connected previously.
| | === How to find the debug console port === |
| Windows users should install the driver for the integrated adapter chip. You can find it on the [http://www.winchiphead.com/download/CH341/CH341SER.ZIP official site] or somewhere else.
| |
| The connection setting are the same as for the old models: '''115200 8N1''' (115200 kbit per second, 8 data bits, no parity bit, one stop bit). You can find the serial port number in the Windows Device Manager.
| |