12 063
правки
(не показаны 3 промежуточные версии этого же участника) | |||
Строка 20: | Строка 20: | ||
#*(for WB5 version.3) close the FW jumper next to the Micro USB connector; | #*(for WB5 version.3) close the FW jumper next to the Micro USB connector; | ||
#*(for the version of WB5.6+) hold down the small button next to the microUSB connector. | #*(for the version of WB5.6+) hold down the small button next to the microUSB connector. | ||
#Without removing the jumper/hanging the button, connect the power to the controller, wait a few seconds and run <syntaxhighlight lang="bash">$ sudo ./mxsldr /X/XX/wb5_usbfw.sb</syntaxhighlight> Where /X/XX/wb5_usbfw.sb is the path to the downloaded file. | |||
#Without removing the jumper/hanging the button, connect the power to the controller, wait a few seconds and run | |||
<syntaxhighlight lang="bash">$ sudo ./mxsldr /X/XX/wb5_usbfw.sb</syntaxhighlight> | |||
Where /X/XX/wb5_usbfw.sb is the path to the downloaded file. | |||
#If the image is successfully loaded after a few seconds, the green led will flash and the controller memory will be detected as a drive on the computer. | #If the image is successfully loaded after a few seconds, the green led will flash and the controller memory will be detected as a drive on the computer. | ||
#Then: | #Then: | ||
Строка 41: | Строка 38: | ||
#*''/X/XX/XXXXX_emmc_wb5.img'' - replace with the path to the pre-extracted firmware file, | #*''/X/XX/XXXXX_emmc_wb5.img'' - replace with the path to the pre-extracted firmware file, | ||
#*''/dev/sdX'' - replace with the name of the partition under which the drive is defined in the system, | #*''/dev/sdX'' - replace with the name of the partition under which the drive is defined in the system, | ||
#:and run the command | #:and run the command <syntaxhighlight lang="bash">$ sudo dd if=/X/XX/XXXXX_emmc_wb5.img of=/dev/sdX bs=1M conv=fdatasync && sync</syntaxhighlight> | ||
<syntaxhighlight lang="bash">$ sudo dd if=/X/XX/XXXXX_emmc_wb5.img of=/dev/sdX bs=1M conv=fdatasync && sync</syntaxhighlight> | |||
#After recording is complete, disconnect the controller from the USB, turn off the controller, and then turn it back on. | #After recording is complete, disconnect the controller from the USB, turn off the controller, and then turn it back on. |
правки