WBE2-I-RS232 RS-232 Extension Module/en: различия между версиями
(Новая страница: «==Configuration==») |
(Новая страница: «Configuration is done in the web interface. Section Configs => Hardware Modules Configuration. Next, in Internal slot 1 or in Internal slot 2, select "WBE2-I-RS23…») |
||
Строка 29: | Строка 29: | ||
==Configuration== | ==Configuration== | ||
Configuration is done in the web interface. Section Configs => Hardware Modules Configuration. | |||
Next, in Internal slot 1 or in Internal slot 2, select "WBE2-I-RS232: RS-232 interface module" and click Save. | |||
Версия 16:32, 26 июня 2019
Hardware
The module is based on the MAX202 chip and provides +/- 10V signal levels.
Pinout
The RS-232 signals are output to the terminals of the O1-O3 extension module.
Pinout:
Terminal | Function |
---|---|
O1 | RX |
O2 | TX |
O3 | GND |
Configuration
Configuration is done in the web interface. Section Configs => Hardware Modules Configuration. Next, in Internal slot 1 or in Internal slot 2, select "WBE2-I-RS232: RS-232 interface module" and click Save.
Устройство определяется сразу же, перезагрузка не требуется.
Работа
Порт доступен в системе как
- /dev/ttyMOD1 - при установке в первый модуль расширения (MOD1)
- /dev/ttyMOD2 - при установке во второй модуль расширения (MOD2)
Для работы нужно отключить аппаратный контроль потока.