WB 5: Errata/en: различия между версиями
(Новая страница: «Scheduled for correction in devices shipped after 10.2016.») |
(Новая страница: «====Reasons and detailed description====») |
||
(не показано 5 промежуточных версий этого же участника) | |||
Строка 82: | Строка 82: | ||
====Reasons and detailed description==== | ====Reasons and detailed description==== | ||
Затвор транзистора на выходе A4 неправильно подтянут. | |||
==== | ====Пути обхода==== | ||
* ( | * (предпочтительный) Не подключать БП к входам A1-A4 напрямую, подключать через резистор в 1-10кОм. С этим сопротивлением дискретный и аналоговый входы будут работать, но при этом включение транзистора (A4 или любого другого) не приведёт к выгоранию выхода. | ||
* | * Отправить устройства на гарантийный ремонт | ||
==== | ====Запланированное исправление==== | ||
Запланировано к исправлению в устройствах, отгруженных после 10.2016. |
Версия 20:33, 27 июня 2019
0530001: Ethernet Problems
Affected devices
Description
Sometimes, when you turn on the Ethernet controller, it is in a non-working state. Traffic does not go in both directions, despite the presence of the link. The green light on the Ethernet connector flashes frequently.
Reasons and detailed description
The ACT led is used in the PHY to set PHY mode. Incorrect connection of the led in the circuit makes the levels setting the PHY mode random.
Workarounds
The hardware fix is to solder the R83 resistor on the back of the Board under the Ethernet connector.
The software fix is to run ifdown eth0 ; ifup eth0 or ifconfig eth0 down ; ifconfig eth0 up to reinitialize the interface.
It is recommended to use the watchdog daemon to check the network availability.
=Scheduled fix
Fixed in revisions 5.6.
0530002: the ACT led on the Ethernet connector does not work
Affected devices
Wiren Board 5 rev. 5.3, shipped after 20.03.2016
Description
The left led (ACT) on the Ethernet connector does not work.
Reasons and detailed description
See 053001 above.
Workarounds
no
=Scheduled fix
Fixed in rev. 5.6.
0530003: Undefined A4 output state
Affected devices
Wiren Board 5 rev. 5.3, 5.6, 5.6.1
Description
When the controller is turned on, the A4 output may be in the open or semi-open state. If a power supply is directly connected to the A4 terminal block (the terminal block is used as an input), a short circuit on the power supply line may occur when the controller is switched on, and the output stage of the A4 output may burn.
Reasons and detailed description
Затвор транзистора на выходе A4 неправильно подтянут.
Пути обхода
- (предпочтительный) Не подключать БП к входам A1-A4 напрямую, подключать через резистор в 1-10кОм. С этим сопротивлением дискретный и аналоговый входы будут работать, но при этом включение транзистора (A4 или любого другого) не приведёт к выгоранию выхода.
- Отправить устройства на гарантийный ремонт
Запланированное исправление
Запланировано к исправлению в устройствах, отгруженных после 10.2016.