12 063
правки
Первое включение Wiren Board/en: различия между версиями
Первое включение Wiren Board/en (просмотреть исходный код)
Версия 18:26, 27 ноября 2019
, 4 года назадНет описания правки
(Новая страница: «Connect the external power supply to the power jack. Or supply power to terminals 17 (Vin) and 18 (GND). Permissible voltage range - 5-22 V.») |
|||
| (не показано 7 промежуточных версий этого же участника) | |||
| Строка 2: | Строка 2: | ||
[[File:Antenna Wi-fi.JPG|thumb|300px|wifi antenna Connection]] | [[File:Antenna Wi-fi.JPG|thumb|300px|wifi antenna Connection]] | ||
[[File:Antenna GPS.JPG|thumb|300px|Connecting GPS and GSM antennas]] | [[File:Antenna GPS.JPG|thumb|300px|Connecting GPS and GSM antennas]] | ||
[[File: | [[File:Разъем_карты.JPG|thumb|300px|Memory card slot]] | ||
=== Antenna connection === | === Antenna connection === | ||
| Строка 27: | Строка 27: | ||
=== Debug UART === | === Debug UART === | ||
See [[WB_Debug_Console/en | here ]]. | |||
For Windows users: download [http://www.chiark.greenend.org.uk/~sgtatham/putty/download.html Putty ] and run it. | |||
In the settings, specify the connection type - serial, speed - 115200, line - COM3 (usually COM3, otherwise see the device Manager list of ports). | |||
[[Файл:Настройки_Путти.jpg |thumb|300px| | [[Файл:Настройки_Путти.jpg |thumb|300px| Putty settings]] | ||
Connect the USB-UART adapter. Open the session. | |||
Now when you turn on the WirenBoard should immediately display the Linux console at boot. | |||
[[ | [[File:Консоль.JPG |thumb|300px| Console at boot]] | ||
If this does not happen, you may have confused Rx and Tx. Or for any other reason. | |||