7809
правок
Includes. Relay tuning/en: различия между версиями
Нет описания правки
Fizikdaos (обсуждение | вклад) (Новая страница: «There could be no registers 9 etc. in outdated firmware. You can only set mode for all their channels at once. To do so, write corresponding number to holding reg…») |
Fizikdaos (обсуждение | вклад) |
||
| (не показано 10 промежуточных версий этого же участника) | |||
| Строка 1: | Строка 1: | ||
<languages/> | <languages/> | ||
Device Setup | == Device Setup == | ||
===Safe mode=== | |||
| Строка 14: | Строка 14: | ||
Relay operation in case of power failure | ===Relay operation in case of power failure=== | ||
| Строка 22: | Строка 22: | ||
Digital inputs | ===Digital inputs=== | ||
| Строка 34: | Строка 34: | ||
You can enable direct control of the relay outputs from the digital inputs in the relay module. There are several options for such management: | You can enable direct control of the relay outputs from the digital inputs in the relay module. There are several options for such management: | ||
* Simple: | |||
** '''Mode 0''': managing switch without detent (click "self-released back"). You press the button (close the digital input with GND), it is "pressed back", the relay state is switched to the opposite. | |||
** '''Mode 1''': switch control with locking. The relay is always set according to the position of the switch. If the switch is "on" (closes the digital input with GND), the relay is also closed. If the switch is "off", the relay is open. | |||
** '''Mode 3''': relay output control from digital input is disabled. | |||
* Complex: | |||
** '''Mapping-matrix''' (see detailed description below) | |||
| Строка 49: | Строка 48: | ||
==== Mapping- | ==== Mapping-matrix ==== | ||
Starting from firmware v.1.9.0, '''mode 2''' is also provided for individual channels-disable all outputs, and '''operating modes (4 and 5)''' in accordance with the mapping matrix (see below).In this and later versions of firmware versions modules have flexible settings of the interaction of inputs and outputs of relay modules using a special mapping matrix: a table in which for each input is encoded change of any relay output state when the state of this input changes. A detailed description can be found in [[I/O_Mapping_Matrix/en|I/O Mapping Matrix]]. | |||