wb_editors
14 355
правок
(Новая страница: «'''Warning: the sensor does not respond to smoke!'''») |
FuzzyBot (обсуждение | вклад) (Часть переводимой страницы WB-MSW v.3.) |
||
(не показано 13 промежуточных версий 2 участников) | |||
Строка 290: | Строка 290: | ||
'''Warning: the sensor does not respond to smoke!''' | '''Warning: the sensor does not respond to smoke!''' | ||
== | == Representation of WB-MSW v.3 in the Wiren Board web interface == | ||
The table lists the names of the parameters measured by the module and their values. The names of parameters that are not supported by a particular module will be highlighted in red. | |||
[[File:WB-MSW3-WEB.png|600px|thumb|right| | [[File:WB-MSW3-WEB.png|600px|thumb|right|WB-MSW v.3 module controls and displays in the web interface]] | ||
{| class="wikitable" | {| class="wikitable" | ||
! | ! Parameter | ||
! | ! Value | ||
|- | |- | ||
| Temperature | | Temperature | ||
| | | Internal sensor temperature | ||
|- | |- | ||
| Humidity | | Humidity | ||
| | | Relative humidity percentage | ||
|- | |- | ||
| Air Quality (VOC) | | Air Quality (VOC) | ||
| | | Air quality (FISHING) in ppm | ||
|- | |- | ||
| CO2 | | CO2 | ||
| | | Co<sub>2</sub> concentration in PPM | ||
|- | |- | ||
| Sound Level | | Sound Level | ||
| | | Sound pressure in dB | ||
|- | |- | ||
| | | Illumination | ||
| | | Illumination in Lux | ||
|- | |- | ||
| Max Motion | | Max Motion | ||
| | | Maximum averaged value of the motion sensor for the last N seconds (N — adjustable parameter, register 282) | ||
|- | |- | ||
| Current Motion | | Current Motion | ||
| | | The average value of the motion sensor for a short interval of time | ||
|- | |- | ||
| Buzzer | | Buzzer | ||
| | | Enable(ON)/disable(OFF) beep sound | ||
|- | |- | ||
| Red LED | | Red LED | ||
| | | On/off flashing red led | ||
|- | |- | ||
| Green LED | | Green LED | ||
| | | On/off flashing red led | ||
|- | |- | ||
| LED Period (s) | | LED Period (s) | ||
The period between flashes of the LEDs in seconds | |||
|- | |- | ||
| LED Glow Duration (ms) | | LED Glow Duration (ms) | ||
| | | Duration of led flashes in milliseconds | ||
|- | |- | ||
| Learn to RAM — Reset all ROM | | Learn to RAM — Reset all ROM | ||
| | | IR control transmitter, see [[WB-MSx_Consumer_IR_Manual |control via IR]] | ||
|- | |- | ||
| Input Voltage | | Input Voltage | ||
| | | Input voltage in volts | ||
|- | |- | ||
| Serial | | Serial | ||
| | | Device serial number | ||
|- | |- | ||
|} | |} | ||
== | == Additional functions== | ||
''' | '''Address change''' is broadcast (slave_id 0) team record (WRITE_SINGLE_REGISTER) to holding register with address 128 (0x80). | ||
== | == Device firmware update == | ||
Starting with the new firmware versions of the device, the firmware update functionality (firmware) via the Modbus Protocol is supported. This makes it possible to extend the functionality of the devices and eliminate errors in the firmware directly at the installation site. | |||
Read more about flashing devices described in the article [[WB-MCU-Flasher/en|Download firmware to Wiren Board devices]]. | |||
A list of firmware versions that support the update, as well as devices for which this feature is implemented, can be found in [[Firmware_Changelog/en| Firmware_Changelog ]]. | |||
== | ==Modbus Control== | ||
Details of the work with the module via Modbus Protocol is written in [[Relay Module Modbus Management/en| Relay Modules Modbus Management ]]. | |||
There you can also find a map of the device registers. | |||
[[Периферийные устройства с интерфейсом RS-485 серии WB-xxxx | | [[Периферийные устройства с интерфейсом RS-485 серии WB-xxxx/en |Back to peripheral devices list]] | ||
== | == Images and drawings of the device == | ||
<!--{{Wbincludes:WBPicturesNoDrawing|1}}--> | <!--{{Wbincludes:WBPicturesNoDrawing|1}}--> | ||
{{Wbincludes:WBPictures|1}} | {{Wbincludes:WBPictures|1}} |