WB-MGE Modbus-Ethernet Interface Converter/en: различия между версиями

The WB-MGE module connects to the local Ethernet network to the router port or directly to one of the Ethernet ports of the Wireless Board programmable controller.

Power is supplied to the V+ and GND terminals of the WB-MGE module. The module '''does NOT '''support PoE power.

On the default Ethernet network, WB-MGE has a static IP address of 192.168.0.7. '''Attention''': if the local network uses a range of addresses other than 192.168.0.0/24, then when connecting through the router '''communication with the device will disappear''' and additional configuration will be required. Detailed instructions on configuring the Ethernet part of WB-MGE can be found on [[WB-MIO-E_AND_WB-MGE_Ethernet_Connection_Setup/en|configuring Ethenet interfaces and connecting WB-MIO-E and WB-MGE modules]].

==The Modbus-registers==

A description of the registers can be found on [[WB-MIO/en#Modbus Control|WB-MIO and WB-MIO-E interface Converters]] in the "Modbus Control" section.

== Images and drawings of the device ==