Translations:RS-485: Wiring and Connection/9/en: различия между версиями

Материал из Wiren Board
м (FuzzyBot переименовал страницу Translations:RS-485:Физическое подключение/9/en в Translations:RS-485: Wiring and Connection/9/en без оставления перенаправления: Часть переводимой страницы RS-485:Физическое подключение.)
 
(не показана 1 промежуточная версия 1 участника)
Строка 1: Строка 1:
{{|1= When connecting external devices to the Wiren Board via the RS-485 bus, it is necessary to connect not only the data lines A and B, but also the ground (common wire) of the Wiren Board controller and external devices. The connection of a common wire is required when connected to an uninsulated RS-485 port and is recommended when connected to a galvanically isolated port.}}
{{warning|1= When connecting external devices to the Wiren Board via the RS-485 bus, it is necessary to connect not only the data lines A and B, but also the ground (common wire) of the Wiren Board controller and external devices. The connection of a common wire is required when connected to an uninsulated RS-485 port and is recommended when connected to a galvanically isolated port.}}
The common wire terminal is designated, according to the equipment, as SC, SG, G, GND, ground or reference. On the Wiren Board controllers, this terminal is designated as GND. When connecting to an isolated port, you need to connect to the isolated ground of the port ("GND iso"terminals).
The common wire terminal is designated, according to the equipment, as SC, SG, G, GND, ground or reference. On the Wiren Board controllers, this terminal is designated as GND. When connecting to an isolated port, you need to connect to the isolated ground of the port ("GND iso"terminals).

Текущая версия на 12:09, 17 июня 2022

Определение сообщения (RS-485: Wiring and Connection)
Клемма общего провода обозначается, в зависимости от оборудования, как SC, SG, G, GND, ground или reference. На контроллерах Wiren Board эта клемма обозначена как GND. При подключении к изолированному порту, нужно подключаться к изолированной земле данного порта (клеммы "GND iso").

{{#invoke:Template translation|renderTranslatedTemplate|template=Template:Warning|noshift=1}} The common wire terminal is designated, according to the equipment, as SC, SG, G, GND, ground or reference. On the Wiren Board controllers, this terminal is designated as GND. When connecting to an isolated port, you need to connect to the isolated ground of the port ("GND iso"terminals).

Источник — https://wirenboard.com/wiki/index.php?title=Translations:RS-485:_Wiring_and_Connection/9/en&oldid=63516