WBE-DI-DR-3/en: различия между версиями
Fizikdaos (обсуждение | вклад) (Новая страница: «Installed in slot MOD-1 or MOD-2 controller Wiren Board 5.») |
|||
(не показано 9 промежуточных версий 1 участника) | |||
Строка 5: | Строка 5: | ||
[[Файл:EXT1.jpeg|thumb|300px|Extension Module WBE-DI-DR-3]] | [[Файл:EXT1.jpeg|thumb|300px|Extension Module WBE-DI-DR-3]] | ||
The module for connection of sensors, counters to the outputs of the type [["Сухой контакт" | The module for connection of sensors, counters to the outputs of the type [[Special:MyLanguage/"Сухой контакт"|"Dry contact"]] or "open collector". | ||
State of logic low: input in air. | State of logic low: input in air. | ||
Строка 11: | Строка 11: | ||
State of logical high: input is connected to ground (GND) of the controller. It allowed to connect either directly or through the resistance less than 300 ohms. | State of logical high: input is connected to ground (GND) of the controller. It allowed to connect either directly or through the resistance less than 300 ohms. | ||
Installed in slot MOD-1 or MOD-2 controller [[Special:MyLanguage/Wiren Board 5| Wiren Board 5]]. | Installed in slot MOD-1 or MOD-2 controller [[Special: MyLanguage / Wiren Board 5 | Wiren Board 5]]. | ||
Три канала. | |||
=== | === Распиновка: === | ||
{| class="wikitable" | {| class="wikitable" | ||
! | !Клемма | ||
! | !Функция | ||
|- | |- | ||
|O1 | |O1 | ||
| | |Вход 1 | ||
|- | |- | ||
|O2 | |O2 | ||
| | |Вход 2 | ||
|- | |- | ||
|O3 | |O3 | ||
| | |Вход 3 | ||
|} | |} | ||
Строка 36: | Строка 36: | ||
==== | ==== При установке в MOD-1 ==== | ||
{| class="wikitable" | {| class="wikitable" | ||
! | !Вход | ||
!GPIO | !GPIO | ||
|- | |- | ||
Строка 53: | Строка 53: | ||
==== | ==== При установке в MOD-2 ==== | ||
{| class="wikitable" | {| class="wikitable" | ||
! | !Вход | ||
!GPIO | !GPIO | ||
|- | |- |
Версия 17:12, 14 января 2016
Extension Module, 3 digital inputs
The module for connection of sensors, counters to the outputs of the type "Dry contact" or "open collector".
State of logic low: input in air.
State of logical high: input is connected to ground (GND) of the controller. It allowed to connect either directly or through the resistance less than 300 ohms.
Installed in slot MOD-1 or MOD-2 controller Wiren Board 5.
Три канала.
Распиновка:
Клемма | Функция |
---|---|
O1 | Вход 1 |
O2 | Вход 2 |
O3 | Вход 3 |
GPIO
При установке в MOD-1
Вход | GPIO |
---|---|
O1 | 85 |
O2 | 76 |
O3 | 91 |
При установке в MOD-2
Вход | GPIO |
---|---|
O1 | 22 |
O2 | 23 |
O3 | 83 |