Translations:Disassembling the controller case/14/en: различия между версиями
Matveevrj (обсуждение | вклад) |
Matveevrj (обсуждение | вклад) |
||
Строка 1: | Строка 1: | ||
#Place the controller board in the case. | #Place the controller board in the case. | ||
#Make sure the '''On/Off''' switch on the front panel is in its aperture. Do not apply excessive force to avoid damaging the switch. | #Make sure the '''On/Off''' switch on the front panel is in its aperture. Do not apply excessive force to avoid damaging the switch. | ||
#Slightly bend back the side wall of the case | #Slightly bend back the side wall of the case where a connector for linking external modules is located. Gently press the board into the case so that the connector fits into the opening in the side of the case. | ||
#Install the back cover. Lid latches should click into place. | #Install the back cover. Lid latches should click into place. |
Версия 20:32, 17 августа 2022
- Place the controller board in the case.
- Make sure the On/Off switch on the front panel is in its aperture. Do not apply excessive force to avoid damaging the switch.
- Slightly bend back the side wall of the case where a connector for linking external modules is located. Gently press the board into the case so that the connector fits into the opening in the side of the case.
- Install the back cover. Lid latches should click into place.