Translations:Disassembling the controller case/14/en: различия между версиями
Matveevrj (обсуждение | вклад) (Новая страница: «'''Step 1'''. Place the controller board in the case.») |
Matveevrj (обсуждение | вклад) |
||
(не показаны 4 промежуточные версии 2 участников) | |||
Строка 1: | Строка 1: | ||
''' | #Place the controller board in the case. | ||
#Make sure the '''On/Off''' switch on the front panel is in its aperture. Do not apply excessive force to avoid damaging the switch. | |||
#Slightly bend back the side wall of the case where the connector for linking external modules is located. Gently press the circuit board into the case so that the connector fits into the aperture in the side of the case. | |||
#Install the back cover. The cover latches should close whith a clicking sound. |
Текущая версия на 20:42, 17 августа 2022
- Place the controller board in the case.
- Make sure the On/Off switch on the front panel is in its aperture. Do not apply excessive force to avoid damaging the switch.
- Slightly bend back the side wall of the case where the connector for linking external modules is located. Gently press the circuit board into the case so that the connector fits into the aperture in the side of the case.
- Install the back cover. The cover latches should close whith a clicking sound.