Wiren Board 5: Модуль расширения ADC/en: различия между версиями
Fizikdaos (обсуждение | вклад) (Новая страница: «=== Operation ===») |
Fizikdaos (обсуждение | вклад) (Новая страница: «3. "Resistance" jumper installed . Measurement of resistance of 0.1-10 ohms. Measuring accuracy up to 0.2% (with R ~ 1k).») |
||
(не показаны 4 промежуточные версии этого же участника) | |||
Строка 7: | Строка 7: | ||
2. "Current" jumper installed . Mode input current up to 70 mA. Measurement accuracy - 1%. Range - up to 70 mA. | 2. "Current" jumper installed . Mode input current up to 70 mA. Measurement accuracy - 1%. Range - up to 70 mA. | ||
For connecting current sensors. | |||
3. "Resistance" jumper installed . Measurement of resistance of 0.1-10 ohms. Measuring accuracy up to 0.2% (with R ~ 1k). | 3. "Resistance" jumper installed . Measurement of resistance of 0.1-10 ohms. Measuring accuracy up to 0.2% (with R ~ 1k). | ||
Подключение датчиков типа Pt100, Pt1000, термисторов от 100 Ом до 10кОм. | |||
4. | 4. Подключение датчика Pt100, Pt1000 по трех проводной схеме. Замкнута только одна перемычка "Resistance 1". Схема подключения на рисунке. | ||
Такое подключение позволяет учитывать сопротивление подводящих проводов, измерение получается более точным. | |||
O1 - GND. | O1 - GND. | ||
Строка 21: | Строка 21: | ||
=== | === ПО === | ||
To be done | To be done |
Версия 17:56, 14 января 2016
Universal module ADC. 12 bits. Adjustable gain (1-12 times) can accurately measure even small voltage
Three modes of operation:
1. ADC mode (jumpers open). Range of measurement is 0-3,3 V.
2. "Current" jumper installed . Mode input current up to 70 mA. Measurement accuracy - 1%. Range - up to 70 mA. For connecting current sensors.
3. "Resistance" jumper installed . Measurement of resistance of 0.1-10 ohms. Measuring accuracy up to 0.2% (with R ~ 1k).
Подключение датчиков типа Pt100, Pt1000, термисторов от 100 Ом до 10кОм.
4. Подключение датчика Pt100, Pt1000 по трех проводной схеме. Замкнута только одна перемычка "Resistance 1". Схема подключения на рисунке. Такое подключение позволяет учитывать сопротивление подводящих проводов, измерение получается более точным.
O1 - GND. O2 - INPUT2 О3 - INPUT1
ПО
To be done