Translations:WB Debug Console/6/en: различия между версиями
Fizikdaos (обсуждение | вклад) |
Fizikdaos (обсуждение | вклад) |
||
Строка 5: | Строка 5: | ||
## TX to RX | ## TX to RX | ||
## RX to the TX | ## RX to the TX | ||
#: <I> (note: some adapters confused labeling - in this case, try to connect the TX to the TX and RX to RX) </ i> | #: <I> (note: some adapters confused labeling - in this case, try to connect the TX to the TX and RX to RX) </i> |
Версия 20:09, 18 января 2016
Debug port on the controller placed into three-pin: GND, RX and TX. To connect:
- Insert the USB-UART Adapter into your computer.
- Plug the connector pins to the pins of the adapter according to the scheme:
- GND to GND
- TX to RX
- RX to the TX
- (note: some adapters confused labeling - in this case, try to connect the TX to the TX and RX to RX)