Wbincludes:Peripherals/en: различия между версиями

<noinclude>{{Warning Editing Inсlude}}</noinclude>

<h2>Introduction</h2>

The easiest and most convenient way to work with the controller hardware is via [[MQTT]], by contacting wb services: wb-mqtt-gpio, wb-mqtt-adc, wb-mqtt-gpio, etc. wb- services allow you to work with hardware through a unified interface [[MQTT]] and hide hardware differences between [[Controller_hardware_revisions|hardware revisions]] controllers.

Work bypassing the standard wb- services is usually used when the software is running on different Linux controllers from different vendors, and work through the corresponding kernel interfaces is already implemented in the software. This article contains a description of the peripherals needed to work with them through the standard kernel interfaces. When working with kernel interfaces, don't forget to disable the corresponding wb- service.

Most of the peripherals described in this article are also described in the /wirenboard node in the controller's Device Tree. Services wb-mqtt-gpio, wb-mqtt-adc, etc. [https://github.com/wirenboard/wb-mqtt-gpio/blob/master/generate-system-config.sh take] the description of the peripherals from there, reading the description every time the controller starts. This method is also preferred for third party software to maintain compatibility with past and future [[Controller_hardware_revisions|hardware revisions]] hardware.

'''WARNING:''' do not directly connect signals with a voltage greater than 3.3V to the controller's GPIO! If you need to connect a device that produces a signal with a higher voltage, use matching circuits. In some cases, if the signal voltage is not more than 5 V, then it is possible to match the signals through a 20 kΩ resistor.

</div>

<div lang="ru" dir="ltr" class="mw-content-ltr">

</div>