16 284
правки
Fast Modbus/en: различия между версиями
Новая страница: «==Scanning devices on the bus== 300px|thumb|right|Scanning devices on the ''Settings → Scanning'' tab Usually, an installation includes several slave devices on one RS-485 bus inside a panel or in the field. Each device has an address that the user can change. During installation, the addresses of slave devices are written down from the device casing and manually entered into the master configuration. This is not very convenient....»
(Новая страница: «===Support for events in firmware=== The table below shows the devices and firmware versions that introduced support for events. {| border="1" class="wikitable" ! Device || Firmware version with event support |- | WB-MRx, WB-MWAC | 1.20.0 |- | WB-MDM3 | 2.7.0 (in testing) |- | WB-LED, WB-MRGBW-D | 3.4.0 |- | WB-MSWx | 4.31.0 (in testing) |- | WB-M1W2 | 4.32.0 (in testing) |- |}») Метки: правка с мобильного устройства правка из мобильной версии |
(Новая страница: «==Scanning devices on the bus== 300px|thumb|right|Scanning devices on the ''Settings → Scanning'' tab Usually, an installation includes several slave devices on one RS-485 bus inside a panel or in the field. Each device has an address that the user can change. During installation, the addresses of slave devices are written down from the device casing and manually entered into the master configuration. This is not very convenient....») Метки: правка с мобильного устройства правка из мобильной версии |
||
| Строка 84: | Строка 84: | ||
|} | |} | ||
==Scanning devices on the bus== | |||
[[Image:Scan-screen.png|300px|thumb|right|Scanning devices on the ''Settings → Scanning'' tab]] | |||
[[Image: Scan-screen.png |300px|thumb|right| | Usually, an installation includes several slave devices on one RS-485 bus inside a panel or in the field. Each device has an address that the user can change. During installation, the addresses of slave devices are written down from the device casing and manually entered into the master configuration. This is not very convenient. | ||
To simplify device configuration, there is a bus scanning function. It was available in the Wiren Board controller even before the Quick Modbus extension was released. With the release of the extension, the ability to quickly scan the bus without waiting for a timeout for each non-existent address was added. | |||
<div lang="ru" dir="ltr" class="mw-content-ltr"> | <div lang="ru" dir="ltr" class="mw-content-ltr"> | ||