Translations:Wiren Board 5:Аппаратная часть/350/en: различия между версиями

Материал из Wiren Board
(Новая страница: «Input stage of Ax channel consists of an analogue-to-digital converter ADCx and an input resistor Rx (100kOhm). The ADC has a high input impedance, so it doesn'…»)
 
 
Строка 6: Строка 6:


If the channel terminal is left floating, the input voltage measured by ADCs is pulled down to zero by the Rx resistance.
If the channel terminal is left floating, the input voltage measured by ADCs is pulled down to zero by the Rx resistance.
Analog inputs on Ax channels are shown as "Ax" in software.  Channel address is "wb-adc/Ax".

Текущая версия на 12:08, 25 февраля 2016

Определение сообщения (Wiren Board 5:Аппаратная часть)
Для каналов Ax входной каскад образуют аналогово-цифрового преобразователь ADCx и входное сопротивление Rx (100кОм) .
Преобразователь ADCx имеет высокое входное сопротивление, он подключен постоянно и не влияет 
на работу канала в режиме вывода.
В режиме ввода, ключ Tx переводится в Неактивное состояние (разомкнут) и, следовательно, не 
влияет на замер напряжения на клемме канала. Входное сопротивление канала в режиме ввода определяется резистором Rx: если к клемме канала не подключены другие цепи, резистор 
"притянет" входное напряжение к 0 питания и преобразователь ADCx считает напряжение 0.
Аналоговые входы на каналах Ax отображаются в ПО как Ax в разделе ADC. Адрес канала: "wb-adc/Ax".

Input stage of Ax channel consists of an analogue-to-digital converter ADCx and an input resistor Rx (100kOhm).

The ADC has a high input impedance, so it doesn't affect the channel operation even if the channel works as output.

In input mode the Tx switch is inactive (open) and, thus, does not affect voltage measuring at the channel terminals. Input impedance in input mode is determined by the Rx resistance.

If the channel terminal is left floating, the input voltage measured by ADCs is pulled down to zero by the Rx resistance.

Analog inputs on Ax channels are shown as "Ax" in software. Channel address is "wb-adc/Ax".