Translations:WB Debug Console/105/en: различия между версиями
Kilpio (обсуждение | вклад) (Новая страница: «Previous models of Wirenboard controller (including the 5.6 rev) got three pins GND, RX и TX for the debug UART onboard. To use them one had to purchase special…») |
|||
(не показаны 4 промежуточные версии 2 участников) | |||
Строка 1: | Строка 1: | ||
== Physical implementation of the debug console port == | |||
Physically in different versions of the controller the debug port is implemented on different: | |||
* for versions ''WB 6 and higher revisions it looks like a Micro-USB connector (signed 'Debug Console'); | |||
* for versions ''WB 5.8 and 5.9' it looks like a Micro-USB connector (signed 'Debug Console' or 'Debug USB'); | |||
* for versions '''WB 5.6''' and lower, up to version '''2.8''' it looks like a three-pin connector (signed ''Debug UART''). | |||
Programmatically, in all cases, it is a serial port. |
Текущая версия на 16:25, 7 июня 2019
Physical implementation of the debug console port
Physically in different versions of the controller the debug port is implemented on different:
- for versions WB 6 and higher revisions it looks like a Micro-USB connector (signed 'Debug Console');
- for versions WB 5.8 and 5.9' it looks like a Micro-USB connector (signed 'Debug Console' or 'Debug USB');
- for versions WB 5.6 and lower, up to version 2.8 it looks like a three-pin connector (signed Debug UART).
Programmatically, in all cases, it is a serial port.