Translations:Disassembling the controller case/24/en: различия между версиями
Matveevrj (обсуждение | вклад) (Новая страница: «# Put the back cover controller up. # Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with professional latches. # Use a screwdriver to bend the remaining latches and get the cover. # Lightly bend the side wall of the case where the connector for connecting external modules is located, and push the controller connector out of the case. He did not become high-r...») |
|||
(не показано 13 промежуточных версий 1 участника) | |||
Строка 1: | Строка 1: | ||
# | # Place the controller back cover up. | ||
# Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with | # Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with all other latches. | ||
# Use a screwdriver to bend the remaining latches and | # Use a screwdriver to bend back the remaining latches and take off the cover. | ||
# | # Slightly bend back the side wall of the case where a connector for linking external modules is located, and push the circuit board out of the case. Don’t push too hard, otherwise you will damage the connector and elements to PCB. |
Текущая версия на 09:02, 19 августа 2022
- Place the controller back cover up.
- Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with all other latches.
- Use a screwdriver to bend back the remaining latches and take off the cover.
- Slightly bend back the side wall of the case where a connector for linking external modules is located, and push the circuit board out of the case. Don’t push too hard, otherwise you will damage the connector and elements to PCB.