Translations:Disassembling the controller case/24/en: различия между версиями

Материал из Wiren Board
 
(не показано 9 промежуточных версий 1 участника)
Строка 1: Строка 1:
# Put the controller back cover up.
# Place the controller back cover up.
# Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with all other latches.
# Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with all other latches.
# Use a screwdriver to bend back the remaining latches and take off the cover.
# Use a screwdriver to bend back the remaining latches and take off the cover.
# Lightly bend back the side wall of the case where an external modules connector is located, and push the controller out of the case. Don't push to hard, so is not to damage the connector.
# Slightly bend back the side wall of the case where a connector for linking external modules is located, and push the circuit board out of the case. Don’t push too hard, otherwise you will damage the connector and elements to PCB.

Текущая версия на 09:02, 19 августа 2022

Определение сообщения (Disassembling the controller case)
# Положите контроллер задней крышкой кверху.
# Вставьте отвертку между защелкой и основанием. Плавным вращательным движением отогните защелку и потяните заднюю крышку вверх. Проделайте то же самое с остальными защелками.
# С помощью отвертки отогните оставшиеся защелки и снимите крышку.
# Слегка отогните боковую стенку корпуса в месте, где расположен разъем для подключения внешних модулей, и вытолкните плату контроллера из корпуса. Не прилагайте больших усилий, чтобы не повредить разъем и элементы на плате.
  1. Place the controller back cover up.
  2. Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with all other latches.
  3. Use a screwdriver to bend back the remaining latches and take off the cover.
  4. Slightly bend back the side wall of the case where a connector for linking external modules is located, and push the circuit board out of the case. Don’t push too hard, otherwise you will damage the connector and elements to PCB.
Источник — https://wirenboard.com/wiki/index.php?title=Translations:Disassembling_the_controller_case/24/en&oldid=66674