Wiren Board 4:Аппаратная часть/en: различия между версиями
(Новая страница: «!colspan="2"| '''Wire Interfaces''' |- | Ethernet || 10/100 Mbit/s, RJ-45 connector |- || USB 2.0 Host || 2 connectors (one connector is located inside the hous…») |
|||
Строка 35: | Строка 35: | ||
!colspan="2"| ''' | !colspan="2"| '''Wire Interfaces''' | ||
|- | |- | ||
| Ethernet || 10/100 | | Ethernet || 10/100 Mbit/s, RJ-45 connector | ||
|- | |- | ||
|| USB 2.0 Host || 2 | || USB 2.0 Host || 2 connectors (one connector is located inside the housing) | ||
|- | |- | ||
|| [[Special:MyLanguage/Аудиовыход| | || [[Special:MyLanguage/Аудиовыход|Audiooutput]] || 3.5 mm connector, stereo | ||
|- | |- | ||
||2x[[Special:MyLanguage/RS-485|RS-485]] ( | ||2x[[Special:MyLanguage/RS-485|RS-485]] (one of the ports is insulated)||software support of Modbus RTU, ADICON/A-BUS/Uniel, and Smartbus G4 protocols | ||
|- | |- | ||
|| | || Debug UART || [[Special:MyLanguage/Debug UART|Debug UART]] connected via USB-UART adapter | ||
|- | |- | ||
|| 2x [[Special:MyLanguage/1-Wire|1-Wire]] || | || 2x [[Special:MyLanguage/1-Wire|1-Wire]] || Connection of temperature and moister sensors | ||
|- | |- | ||
!colspan="2"| ''' | !colspan="2"| '''. Connection of sensors''' | ||
|- | |- | ||
| 5x[[Special:MyLanguage/ADC | АЦП]] || 2x | | 5x[[Special:MyLanguage/ADC | АЦП]] || 2x up to 24V , 3x - up to 5V | ||
|- | |- | ||
||2x[[Special:MyLanguage/Входы для резистивных датчиков| | ||2x[[Special:MyLanguage/Входы для резистивных датчиков|Inputs for resistive sensors]] | ||
|| | || Connection of 10 kOhm thermistors. The controller can be used as ADC up to 3.3V | ||
|- | |- | ||
|| 4x[[Special:MyLanguage/"Сухой контакт"|" | || 4x[[Special:MyLanguage/"Сухой контакт"|"Dry contact"]] | ||
|rowspan="2"| | |rowspan="2"| Connection of pushbuttons, gerkons, counters with pulse outputs | ||
|- | |- | ||
|| 2x[[Special:MyLanguage/DI | DI ( | || 2x[[Special:MyLanguage/DI | DI (digital input)]] | ||
|- | |- | ||