Disassembling the controller case/en: различия между версиями
(Новая страница: «Next, carefully remove the board from the case, which from the connectors of external modules, the Board is slightly raised, and the side wall of the case is pull…») |
(Новая страница: «Assembly is done in reverse order. Note: the groove at the bottom of the case should be located on the side of the SIM card slot. All latches must be closed with…») |
||
| Строка 11: | Строка 11: | ||
Next, carefully remove the board from the case, which from the connectors of external modules, the Board is slightly raised, and the side wall of the case is pulled over. The directions are shown in the figure. Then take out the Board with a little effort, holding it by the edges. | Next, carefully remove the board from the case, which from the connectors of external modules, the Board is slightly raised, and the side wall of the case is pulled over. The directions are shown in the figure. Then take out the Board with a little effort, holding it by the edges. | ||
Assembly is done in reverse order. Note: the groove at the bottom of the case should be located on the side of the SIM card slot. All latches must be closed with a click. | |||
<br /><br /><br /><br /><br /><br /><br /><br /><br /><br /> | <br /><br /><br /><br /><br /><br /><br /><br /><br /><br /> | ||
Версия 19:50, 28 мая 2019
The upper part of the controller body is attached to the base on four plastic latches - two on the left and two on the right side. We begin to open the controller case with a latch marked with number "1" in the figure (we start with the latches in the thick part of the body, because in order to open them, you need to make more effort). Use a plastic spatula or screwdriver with a straight slot (the tip can be wrapped with insulation tape or tape, so as not to scratch the plastic case).
Bend the latch with the rotational movement with a little effort (not to break), while shifting the angle of the lower base to itself, as shown in the figure by the arrows. In the same way, open the symmetrical latch, marked with the number "2". The two remaining latches are easily bent by hands to the left and to the right respectively. The lower part of the case is open.
Next, carefully remove the board from the case, which from the connectors of external modules, the Board is slightly raised, and the side wall of the case is pulled over. The directions are shown in the figure. Then take out the Board with a little effort, holding it by the edges.
Assembly is done in reverse order. Note: the groove at the bottom of the case should be located on the side of the SIM card slot. All latches must be closed with a click.