WBE2-I-RS485-ISO RS485 Extension Module/en: различия между версиями
(Новая страница: «<div class="tright" style="clear:none">thumb|200px| WBE2-I-RS485-ISO reverse side </div> <div class="tright" style="clear:none"…») |
(Новая страница: «RS485 signals are output to the terminals of the O1-O3 extension module.») |
||
Строка 10: | Строка 10: | ||
<div class="tright" style="clear:none">[[Файл:WBE2-I-RS485-ISO2.png|thumb|200px| WBE2-I-RS485-ISO front side]]</div> | <div class="tright" style="clear:none">[[Файл:WBE2-I-RS485-ISO2.png|thumb|200px| WBE2-I-RS485-ISO front side]]</div> | ||
RS485 signals are output to the terminals of the O1-O3 extension module. | |||
{| class="wikitable" | {| class="wikitable" |
Версия 10:48, 27 июня 2019
Module with galvanically isolated RS-485 interface. Insulation voltage: 1.5 kV. Speed up to 1 Mbit/s.
Module contains 120 Ohm terminator between lines A and B. To enable it, close the jumper between termination contacts on the top edge of the board.
Pinout
RS485 signals are output to the terminals of the O1-O3 extension module.
Клемма | Функция |
---|---|
O1 | A (D+) |
O2 | B (D-) |
O3 | Isolated GND (Common, C) |
Конфигурирование
Настройка осуществляется в веб-интерфейсе. Раздел Configs => Hardware Modules Configuration. Далее в Internal slot 1 или в Internal slot 2 выбрать "WBE2-I-RS485-ISO: Isolated RS-485 interface module" и нажать Save.
Устройство определяется сразу же, перезагрузка не требуется.
Работа
Порт доступен в системе как
- /dev/ttyMOD1 - при установке в первый модуль расширения (MOD1)
- /dev/ttyMOD2 - при установке во второй модуль расширения (MOD2)
Для работы необходимо отключить аппаратный контроль потока. Дополнительная конфигурация порта как RS-485 не требуется.