Translations:Notification module/4/en: различия между версиями
Строка 1: | Строка 1: | ||
== Pre-setting for sending SMS== | == Pre-setting for sending SMS== | ||
Make sure you insert the SIM card and connect the GSM antenna. | Make sure you insert the SIM card and connect the GSM antenna. | ||
== Configure the notification module== | |||
#Go to the "Configs - Alarm Configuraion" page of the web interface. | #Go to the "Configs - Alarm Configuraion" page of the web interface. | ||
#Add notification recipients in the "Recipients" section: | #Add notification recipients in the "Recipients" section: | ||
Строка 10: | Строка 10: | ||
#*press "+ Item"; | #*press "+ Item"; | ||
#*in the section that appears, select one of the four notification types from the drop-down list: | #*in the section that appears, select one of the four notification types from the drop-down list: | ||
#*#"Expected Value Alarm" - notification, if the value is no longer equal to the specified value. | #*# "Expected Value Alarm" - notification, if the value is no longer equal to the specified value. | ||
#*#"Minimum Value Alarm" - notification if the value becomes less than the specified value. | #*#"Minimum Value Alarm" - notification if the value becomes less than the specified value. | ||
#*#"Maximum Value Alarm" - notification if the value becomes greater than the specified value. | #*#"Maximum Value Alarm" - notification if the value becomes greater than the specified value. |
Версия 12:52, 19 июля 2019
Pre-setting for sending SMS
Make sure you insert the SIM card and connect the GSM antenna.
Configure the notification module
- Go to the "Configs - Alarm Configuraion" page of the web interface.
- Add notification recipients in the "Recipients" section:
- press "+ Recipient";
- select the type ("E-mail" or "SMS");
- enter your postal address or phone number. You can also specify the subject of the email.
- Configure the parameter and condition to be checked in the "Alarms" section:
- press "+ Item";
- in the section that appears, select one of the four notification types from the drop-down list:
- "Expected Value Alarm" - notification, if the value is no longer equal to the specified value.
- "Minimum Value Alarm" - notification if the value becomes less than the specified value.
- "Maximum Value Alarm" - notification if the value becomes greater than the specified value.
- "Minimum&Maximum Value Alarm" - notification if the value is out of the specified range.
- in "Alarm name" enter an arbitrary name for the notification;
- in "Cell", enter the parameter you want to monitor. The parameter is specified as "Device/Control", where the device and Control names for each parameter can be found on the "Settings" page of the web interface in the "MQTT Channels" table. For example, for a 1-Wire sensor connected to an external Modbus WB-MS sensor, this string would look like "wb-ms-thls-v2_101/External Sensor 2";
- in "Alarm activation message" enter the text of the message to be sent. You can enter two curly brackets "{} " in it in any place, instead of which a new parameter value will be substituted in the message, which is monitored.
- depending on the notification type, fill in the fields "Minimum Value", "Maximum Value", "Expected Value";
- some additional settings will be available if you click on the "Properties" button and check them.
- Click "Save" at the top of the page:
- if you forget to specify some required parameter, the "Save" button will be inactive, and an error will be written next to the parameter in red, which should be corrected;
- if everything is OK, notifications will start working.