Wiren Board 6: The extension module of dry contacts(WBE2-DI-DR-3)
Extension module, 3 digital inputs
The module for connection of sensors, counters to the outputs of the type Dry contact or open collector.
The state of the logical zero: input in the air.
Logical 1 state: the input is connected to the ground (GND) of the controller. It is allowed to connect directly or with resistance no more than 300 Ohms.
Installed in slot MOD-1 or MOD-2 controller Wiren Board 6.
Three channels.
Pinout:
Terminal | Function |
---|---|
O1 | Input 1 |
O2 | Input 2 |
O3 | Input 3 |
Configuration
Configuration of the web interface is carried out in the section Configs => Hardware Modules Configuration.
Select "WBE2-DI-DR-3: digital inputs extension module" in the Internal slot 1 or 2 section (depending on the slot number) and click Save.
Once added, additional inputs appear in Devices next to the controller inputs.
The device is detected immediately, no reboot is required.
MQTT и представление в Web-интерфейсе
Слот | Клемма | Выход | Канал (MQTT) | Топик (MQTT) |
---|---|---|---|---|
MOD1 | O1 | IN1 | wb-gpio/MOD1_IN1 | /devices/wb-gpio/controls/MOD1_IN1 |
O2 | IN2 | wb-gpio/MOD1_IN2 | /devices/wb-gpio/controls/MOD1_IN2 | |
O3 | IN3 | wb-gpio/MOD1_IN3 | /devices/wb-gpio/controls/MOD1_IN3 | |
MOD2 | O1 | IN1 | wb-gpio/MOD2_IN1 | /devices/wb-gpio/controls/MOD2_IN1 |
O2 | IN2 | wb-gpio/MOD2_IN2 | /devices/wb-gpio/controls/MOD2_IN2 | |
O3 | IN3 | wb-gpio/MOD2_IN3 | /devices/wb-gpio/controls/MOD2_IN3 |