Translations:Relay Module Modbus Management/18/en
Версия от 14:34, 16 июля 2019; RomanKulibaba (обсуждение | вклад) (Новая страница: «{| border="1" class="wikitable" style="text-align:center; width:1000px;" !Register / address !Type !Read-write !Default !Format !Appointment !Note |- | 0 .. ('''…»)
Register / address | Type | Read-write | Default | Format | Appointment | Note |
---|---|---|---|---|---|---|
0 .. (x-1) | coil | RW | - | 1 or 0 | relay status with number 1 .. x | |
0 .. (y-1) | discrete | R | - | 1 or 0 | entry status with number 1 .. y | |
5 | holding | RW | 0 |
|
mode of interaction of digital inputs with relay outputs. The input status registers and the pressure counter continue to operate in all modes. | The register was used in the old configuration mechanism. It is recommended to leave it set to 0 and the inputs are configured via the individual registers 9 .. (9+x-1) |
6 | holding | RW |
|
relay operation mode in case of power failure | (only in firmware 1.5.3 and later) | |
8 | holding | RW | 0 | seconds | safe mode timeout |