Translations:WB-MIR v2 - Modbus IR Remote Control/7/en
Версия от 11:06, 23 июля 2019; RomanKulibaba (обсуждение | вклад) (Новая страница: «== Specifications == {| class="wikitable" ! style="text-align: center;" | Option ! style="text-align: center;" | Value |- ! colspan="2" |Power |- |Supply voltage…»)
Specifications
Option | Value |
---|---|
Power | |
Supply voltage | 9 — 24 V DC |
Power consumption |
0.1 W |
Transmitter range | < 1m |
External sensor | Digital temperature sensor DS18B20 can be connected. |
Terminals and wire section | |
Recommended wire cross-section with NSUI, mm2 | 0,75 — 1 |
Length of the standard sleeve NSUI, mm | 8 |
Torque of screws, N∙m | 0,2 |
Control | |
Management interface | RS-485 |
Interface isolation | Uninsulated |
Communication protocol | Modbus RTU, address is set by software, factory settings are indicated on the label |
RS-485 interface parameters |
speed 9600 bps; data bits 8; parity N; stop bits 2; Starting from firmware version 3.1.0 parameters interfaces can be configured programmatically:
|
Number of stored IR commands | |
Number of teams |
|
Command duration | The maximum command length is 508 registers, plus two registers indicates the end of the command.Each register encodes the duration of a high or low signal level (sequentially) in microseconds. |
dimensions | |
L x W x h |
|
operating Conditions | |
Air temperature | -40°C to +80°C |
Relative humidity | up to 98%,without moisture condensate |