Вклад
25 июля 2019
Wiren Board NETMON-1/en
Новая страница: «There are no special current inputs in the Wiren Board NETMON-1, but you can use a resistor 100-300om, convert the current into voltage and connect as in the prev…»
−98
Translations:Wiren Board NETMON-1/74/en
Новая страница: «There are no special current inputs in the Wiren Board NETMON-1, but you can use a resistor 100-300om, convert the current into voltage and connect as in the prev…»
Wiren Board NETMON-1/en
Новая страница: «== Sensors with analog current output ==»
−36
Translations:Wiren Board NETMON-1/73/en
Новая страница: «== Sensors with analog current output ==»
Wiren Board NETMON-1/en
Новая страница: «Connect the ground of the device to the GND terminal, or connect to a common ground bus. The sensor output is connected to analog inputs in A1-A7 connectors.»
−102
Translations:Wiren Board NETMON-1/72/en
Новая страница: «Connect the ground of the device to the GND terminal, or connect to a common ground bus. The sensor output is connected to analog inputs in A1-A7 connectors.»
Wiren Board NETMON-1/en
Новая страница: «=== Sensors with analog voltage output ===»
−45
Translations:Wiren Board NETMON-1/71/en
Новая страница: «=== Sensors with analog voltage output ===»
Wiren Board NETMON-1/en
Новая страница: «Relay in Wiren Board NETMON-1 contains no protective damping chains, aware when connecting inductive loads.»
−122
Translations:Wiren Board NETMON-1/70/en
Новая страница: «Relay in Wiren Board NETMON-1 contains no protective damping chains, aware when connecting inductive loads.»
Wiren Board NETMON-1/en
Новая страница: «Connect the contactor control coil via the relay on the front panel.»
−67
Translations:Wiren Board NETMON-1/69/en
Новая страница: «Connect the contactor control coil via the relay on the front panel.»
Wiren Board NETMON-1/en
Новая страница: «=== Electric contactors with control voltage of 220 V ===»
−26
Translations:Wiren Board NETMON-1/68/en
Новая страница: «=== Electric contactors with control voltage of 220 V ===»
Wiren Board NETMON-1/en
Новая страница: «The low-voltage load can be controlled by four relays on the front panel.»
−80
Translations:Wiren Board NETMON-1/67/en
Новая страница: «The low-voltage load can be controlled by four relays on the front panel.»
Wiren Board NETMON-1/en
Новая страница: «12/24V relays, LEDs, fans, signal lights, etc.»
−65
Translations:Wiren Board NETMON-1/66/en
Новая страница: «12/24V relays, LEDs, fans, signal lights, etc.»
Wiren Board NETMON-1/en
Новая страница: «=== Low voltage load control ===»
−42
Translations:Wiren Board NETMON-1/65/en
Новая страница: «=== Low voltage load control ===»
Wiren Board NETMON-1/en
Новая страница: «thumb|400px|Button connection example»
−46
Translations:Wiren Board NETMON-1/64/en
Новая страница: «thumb|400px|Button connection example»
Wiren Board NETMON-1/en
Новая страница: «== Standard wiring diagrams ==»
−32
Translations:Wiren Board NETMON-1/63/en
Новая страница: «== Standard wiring diagrams ==»
Wiren Board NETMON-1/en
Новая страница: «Wiren Board NETMON-1: List of GPIOs»
−1
Translations:Wiren Board NETMON-1/62/en
Новая страница: «Wiren Board NETMON-1: List of GPIOs»
Wiren Board NETMON-1/en
Новая страница: «== List of GPIOs ==»
−4
Translations:Wiren Board NETMON-1/61/en
Новая страница: «== List of GPIOs ==»
Wiren Board NETMON-1/en
Новая страница: «{|| border="1" class="wikitable" style="text-align:center" |'''Ethernet'''|| |- |1 Y/W|| RS-232 TX (2) |- |2 Y|| RS-232 TX (2) |- |3 G/W|| RS-232 RX (2) |- |4 B|…»
−6
Translations:Wiren Board NETMON-1/60/en
Новая страница: «{|| border="1" class="wikitable" style="text-align:center" |'''Ethernet'''|| |- |1 Y/W|| RS-232 TX (2) |- |2 Y|| RS-232 TX (2) |- |3 G/W|| RS-232 RX (2) |- |4 B|…»
Wiren Board NETMON-1/en
Новая страница: «RJ-45 connector on the rear panel, pinout:»
−30
Translations:Wiren Board NETMON-1/59/en
Новая страница: «RJ-45 connector on the rear panel, pinout:»
Wiren Board NETMON-1/en
Новая страница: «thumb|300px|RJ-45 Pinout on the back of WB NETMON-1»
−49
Translations:Wiren Board NETMON-1/58/en
Новая страница: «thumb|300px|RJ-45 Pinout on the back of WB NETMON-1»
Wiren Board NETMON-1/en
Новая страница: «=== Back panel ===»
−13
Translations:Wiren Board NETMON-1/57/en
Новая страница: «=== Back panel ===»
Wiren Board NETMON-1/en
Новая страница: «thumb|300px|схема передней панели {|| border="1" class="wikitable" style="text-align:center"…»
−20
Translations:Wiren Board NETMON-1/56/en
Новая страница: «thumb|300px|схема передней панели {|| border="1" class="wikitable" style="text-align:center"…»
Wiren Board NETMON-1/en
Новая страница: «thumb|700px| front panel thumb|700px|»
−30
Translations:Wiren Board NETMON-1/55/en
Новая страница: «thumb|700px| front panel thumb|700px|»
Wiren Board NETMON-1/en
Новая страница: «=== Front panel relay ===»
−25
Translations:Wiren Board NETMON-1/54/en
Новая страница: «=== Front panel relay ===»
Wiren Board NETMON-1/en
Новая страница: «For details on working with the debug console, see Debug UART.»
−69
Translations:Wiren Board NETMON-1/53/en
Новая страница: «For details on working with the debug console, see Debug UART.»
Wiren Board NETMON-1/en
Новая страница: «Debug console (debug UART) is output to connector I2 (see below), as well as to the comb inside the case. The port has 3.3 V levels and requires a special USB-UAR…»
−143
Translations:Wiren Board NETMON-1/52/en
Новая страница: «Debug console (debug UART) is output to connector I2 (see below), as well as to the comb inside the case. The port has 3.3 V levels and requires a special USB-UAR…»
Wiren Board NETMON-1/en
Новая страница: «== Debug console ==»
−22
Translations:Wiren Board NETMON-1/51/en
Новая страница: «== Debug console ==»
Wiren Board NETMON-1/en
Новая страница: «See also RS-485 for information on working with RS-485 and connecting peripherals.»
−73
Translations:Wiren Board NETMON-1/50/en
Новая страница: «See also RS-485 for information on working with RS-485 and connecting peripherals.»