История
31 мая 2019
Новая страница: «===Sending and receiving SMS and USSD===»
−16
Новая страница: «To return to IoT mode, run the following command: <pre> AT+CNMP=51 </pre>»
−36
Новая страница: «The mode is remembered and active and after power off, you need to set the mode once.»
−79
Нет описания правки
−1
Новая страница: «Possible values:(ccommand <code>AT+CNMP=?</code>): 2-Automatic,13-GSM Only,38-LTE Only,51-GSM And LTE Only»
−43
Новая страница: «In the terminal mode of the modem, for example, in the minicom program (see below section #низкоуровневая-работа с модулем чере…»
−162
Новая страница: «The SIM7000E 2G/NB-IoT modem is set to select GSM and LTE networks automatically by default. However, in a network or with aSIM card without NB-IoT support, the…»
−163
Новая страница: «=== SIM7000E 2G/NB-IoT modems ===»
−6
Новая страница: «By default, the modem is automatically turned on when the controller boots. Then it can be turned off and reloaded with the '''wb-gsm utility''' (the utility is i…»
−249
Новая страница: «===Enabling the module===»
−14
Новая страница: «Modem control pins PWRKEY and RESET are also connected to the processor, you can turn off or restart the modem using them. Usually you do not need to work with th…»
−290
Новая страница: «Inside the controller, the modem is connected to the processor in one of two ways: *via UART port (device ''/dev/ttyGSM ''(previously: ''/dev/ttyAPP0'')) - all mo…»
−263
Новая страница: «== Modem in Linux ==»
−5
Новая страница: «Connect the antenna and insert the SIM card before starting the controller. If you have enabled the controller without a SIM card, restart the modem using the '''…»
−133
Новая страница: «== Getting started ==»
−10
Новая страница: «The Wiren Board controller is equipped with GSM/GPRS-module which can provide the following functions: *send/receive SMS *connect to the Internet via GPRS See the…»
−165
Новая страница: «GSM/GPRS»
+25 063