Translations:WB Debug Console/6/en
Версия от 14:07, 3 ноября 2018; FuzzyBot (обсуждение | вклад) (FuzzyBot переименовал страницу Translations:Отладочный порт/6/en в Translations:WB Debug Console/6/en без оставления перенаправления: Часть переводимой страни…)
Debug port on the controller placed into three-pin: GND, RX and TX. To connect:
- Insert the USB-UART Adapter into your computer.
- Plug the connector pins to the pins of the adapter according to the scheme:
- GND to GND
- TX to RX
- RX to the TX
- (note: some adapters confused labeling - in this case, try to connect the TX to the TX and RX to RX)