Wiren Board controller: Getting started
Antenna connection
Connector u.fl for WiFi is inside the Wiren Board.
For connecting the antenna you need to remove the red charge, and a light press until it clicks to put the corresponding connector (it is convenient to do that with a pencil).
Antennas for GPS and GSM are connected from the outside of the board.
Do not place the GSM antenna near the processor. Aiming at the quartz of the processor causes it to reboot. Turn the antenna away from the USB and Ethernet connectors (as on the photo).
Flash card
Создайте microSD-карту с образом.
Вставьте в разъем (на боковой стороне платы OLinuXino-MICRO).
Питание
Подключите внешний блок питания в power jack. Или подайте питание на клеммники 17 (Vin) и 18 (GND). Допустимый диапазон напряжений - 5-22 В.
Debug UART
Про Debug UART прочитайте здесь .
Если у вас Windows, скачайте Putty и запустите ее.
В настройках укажите тип соединения - serial, скорость - 115200, линия - COM3 (обычно это COM3, иначе смотрите в диспетчере устройств список портов).
Подключите переходник USB-UART. Откройте сессию.
Теперь при включении WirenBoard должна сразу выводиться консоль линукса при загрузке.
Если этого не произошло, возможно вы перепутали Rx и Tx. Или по другой причине.