Translations:WB-MSW v.3 Modbus Sensor/26/en
Версия от 21:04, 20 апреля 2021; FuzzyBot (обсуждение | вклад) (FuzzyBot переименовал страницу Translations:WB-MSW v.3/26/en в Translations:WB-MSW v.3 Modbus Sensor/26/en без оставления перенаправления: Часть переводимой страницы WB-MSW v.3.)
The screw terminal block of the module is located on its back side and is used to connect power lines (V+ and GND) and control over RS-485 (RS-485 A and B). When using type handpieces for installation of wires in screw clamps, it is necessary that the diameter of the insulated cuffs does not exceed 3.6 mm, the wire section — 0.75 mm2, and the length of the conductive sleeve — 6 mm. Screw clamps also accept wire section up to 1.5 mm2.