Wiren Board 6: DAC extension module (WBE2-AO-10V-2)
Dual-channel extension module DAC (0 — 10 В) WBE2-AO-10V-2
Hardware
The module is built on the MCP4728 digital-to-analog converter and supports two output channels with a voltage from 0 to 10 V. In version 2.2, the output current is increased to 10 mA. The module can withstand short-term (a few seconds) output short-circuit.
Pinout
The signals of the converter are output to the O1-O3 terminals of the extension module.
Pinout:
Terminal | Function |
---|---|
O1 | MOD1_O1 (MOD2_O1) |
O2 | MOD1_O2 (MOD2_O2) |
O3 | GND |
Configuration
Configuration is set in the web interface. Section Configs => Hardware Modules Configuration. Next, in Internal slot 1 or in Internal slot 2, select "WBE2-AO-10V-2: Dual channel analog voltage output (0-10V) module" and click Save.
The device is detected immediately, no reboot is required.
Operation
In the web interface, the module channels appear in the Analog Outputs section and are called MOD1_O1 and MOD1_O2 for the module installed in the first connector, MOD2_O1 and MOD2_O2 for the module installed in the second connector. The voltage value (in millivolts) is published in mqtt-topics /devices/wb-dac/controls/.