12 063
правки
Доступ к порту RS-485 контроллера Wiren Board с компьютера/en: различия между версиями
Доступ к порту RS-485 контроллера Wiren Board с компьютера/en (просмотреть исходный код)
Версия 20:38, 30 мая 2019
, 4 года назадНовая страница: «The -d and -x options can be omitted in both cases - they are needed for diagnostic output and hexadecimal data dumps.»
(Новая страница: «In older versions of controllers, specify ports [/dev/ttyNSC0, /dev/ttyNSC1] or [/dev/ttyAPP1, /dev/ttyAPP4].») |
(Новая страница: «The -d and -x options can be omitted in both cases - they are needed for diagnostic output and hexadecimal data dumps.») |
||
| (не показаны 2 промежуточные версии этого же участника) | |||
| Строка 36: | Строка 36: | ||
In older versions of controllers, specify ports [/dev/ttyNSC0, /dev/ttyNSC1] or [/dev/ttyAPP1, /dev/ttyAPP4]. | In older versions of controllers, specify ports [/dev/ttyNSC0, /dev/ttyNSC1] or [/dev/ttyAPP1, /dev/ttyAPP4]. | ||
After executing these commands, special files /dev/ttyRS485-1 and /dev/ttyRS485-2 appear in the system (on the PC), corresponding to RS-485 ports of the Wiren Board. The latter command creates symbolic links to port files in /dev for convenience, which allows, for example, to use the Modbus driver configuration written for the Wiren Board on a PC without any changes. | |||
RS-485 | |||
The -d and -x options can be omitted in both cases - they are needed for diagnostic output and hexadecimal data dumps. | |||