WBIO-DIO-TTL-8 I/O module
Это утверждённая версия страницы. Она же — наиболее свежая версия.
This model is discontinued.
Purpose
Designed to connect devices with 5V TTL or 5V CMOS signals.
Technical specifications
Contains 8 I/O channels with 5V voltage levels, the default channels are set as output.
| Parameter | Value |
|---|---|
| Number of I/O channels | 8 |
| Isolated input groups | 1 |
| I /O channel type | 5V GPIO |
| A triggering condition of the channel in input mode | input supply 5V |
| Condition for ending actuation of the channel in input mode | connection of the input with GND |
| Minimum voltage of logic unit | 4 V |
| Maximum logic zero voltage | 1 V |
| Maximum output current per channel | 20 mA |
| Maximum output current, all channels | 100 mA |
| Overvoltage protection, up to | +60 V |
| Module type | "O" (non-inverted address scheme) |
| Maximum power consumption | 0.2 W |
| Width, DIN units | 2 |
| Size | 36,3x90,2x57,5 mm |
| "'Terminals and wire section'" | |
|---|---|
| Recommended wire cross-section with TSVI, mm2 | 0,75 — 1 |
| Length of the standard sleeve NSVE, mm | 8 (10 for adjusting screwless terminal blocks) |
| Torque of screws, N∙m | 0,2 (for screw terminals) |
Connection
The controller, module and plug-in device must share a common ground.
Device pictures and drawings
По ссылкам ниже вы можете скачать изображения и чертежи устройства WBIO-DIO-TTL-8.
Corel Draw 2018: WBIO-DIO-TTL-8.cdr.zip
Corel Draw PDF: WBIO-DIO-TTL-8.cdr.pdf
Autocad 2013 DXF: Мы еще не подготовили чертеж этого устройства. Вы можете запросить чертеж устройства "Модуль ввода-вывода с TTL-уровнями WBIO-DIO-TTL-8" на портале техподдержки Wiren Board (необходима регистрация).