Просмотр кода страницы Модуль выходов "сухой контакт" (оптореле) WBE-DO-SSR-2/en

<languages/>
The module is designed to control the inputs of the "dry contact" type in applications where galvanic isolation is required.[[Файл:OPtRel.png|200px|thumb|right|Output contact diagram]]


==Technical specifications==

The module contains two SPST (normally open) configuration optocouplers with one common contact.

Each channel has built-in protection against voltage surges when switching inductive load (TVS at 40V).

{| class="wikitable" style="text-align:center"
!Parameter
!Value
|-
|Number of outputs
|2
|-
|Outputs type
|opto relay
|-
|Contacts configuration
|SPST (normally open)
|-
|Maximum switching voltage
|40V AC/DC
|-
|Maximum switching current, per channel
|'''100 mA'''
|-
|The channel resistance in the open state
|< 5 Оhm
|-
|Voltage isolation between the controller and the output
|1500 Vrms
|-
|Maximum power consumption
|0.05 Вт
|-
|Compatibility
|Compatiblу with [[Wiren Board 5/en|Wiren Board 5]] of all revisions. 
|}


== Pinout ==

 

{| class="wikitable"
!Terminal
!Function
|-
|O1
|K1
|-
|O2
|K2
|-
|O3
|COM
|}


==Configuration==

 Configuration is carried out in the web interface, section Configs => Hardware Modules Configuration. 

Select "WBE-DO-OR-2: Dual Solid-State Signal Relay Module" in the Internal slot 1 or 2 section (depending on the slot number) and click Save.

Once added, two additional outputs appear in the Devices next to the controller outputs (the Discrete I/O section).

When adding a device is detected immediately, a reboot is not required.
[[Файл:OptoRelay.jpg|thumb| WBE-DO-OR-2 for Wiren Board 5
]]


==MQTT ==

{| class="wikitable"
!Slot
!Terminal
!Output
!Channel (MQTT)
!Topic (MQTT)
|-
| rowspan="2" |MOD1
|O1
|K1
|wb-gpio/MOD1_K1
|/devices/wb-gpio/controls/MOD1_K1
|-
|O2
|K2
|wb-gpio/MOD1_K2
|/devices/wb-gpio/controls/MOD1_K2
|-
| rowspan="2" |MOD2
|O1
|K1
|wb-gpio/MOD2_K1
|/devices/wb-gpio/controls/MOD2_K1
|-
|O2
|K2
|wb-gpio/MOD2_K2
|/devices/wb-gpio/controls/MOD2_K2
|}


==Technical detail==

The relay control signals are on the RX (K1) and IRQ (K2) contact of the extension module