12 063
правки
Модуль расширения CAN (WBE-I-CAN-ISO)/en: различия между версиями
Модуль расширения CAN (WBE-I-CAN-ISO)/en (просмотреть исходный код)
Версия 19:02, 1 июля 2019
, 4 года назадНет описания правки
(Новая страница: «For UART-CAN mode: make sure that the corresponding slot (Internal slot 1 or Internal slot 2) is set to "None".») |
|||
| (не показаны 4 промежуточные версии этого же участника) | |||
| Строка 10: | Строка 10: | ||
CAN interface signals are galvanically isolated from the controller. | CAN interface signals are galvanically isolated from the controller. | ||
Can be installed only to MOD2 extension slot. | |||
Can be installed only to | |||
| Строка 52: | Строка 50: | ||
For UART-CAN mode: make sure that the corresponding slot (Internal slot 1 or Internal slot 2) is set to "None". | For UART-CAN mode: make sure that the corresponding slot (Internal slot 1 or Internal slot 2) is set to "None". | ||
The device is detected immediately, no reboot is required. | |||
== Operation == | == Operation == | ||
In CAN mode, it is defined as can1. About can on Linux, see [[CAN/en| CAN]]. | |||
Module operates in UART-CAN mode identically to the RS-485 extension module, see [[Wiren Board 5: Модуль расширения RS485-ISO/en|description]]. | |||
== | == Compatibility table == | ||
{| class="wikitable" | {| class="wikitable" | ||
! | !Mode | ||
! | !Controller | ||
! | !Audit | ||
!MOD1 | !MOD1 | ||
!MOD2 | !MOD2 | ||