Первое включение Wiren Board/en: различия между версиями
(Новая страница: «In the settings, specify the connection type - serial, speed - 115200, line - COM3 (usually COM3, otherwise see the device Manager list of ports).») |
(Новая страница: «thumb|300px| Putty settings Connect the USB-UART adapter. Open the session.») |
||
| Строка 33: | Строка 33: | ||
In the settings, specify the connection type - serial, speed - 115200, line - COM3 (usually COM3, otherwise see the device Manager list of ports). | In the settings, specify the connection type - serial, speed - 115200, line - COM3 (usually COM3, otherwise see the device Manager list of ports). | ||
[[Файл:Настройки_Путти.jpg |thumb|300px| | [[Файл:Настройки_Путти.jpg |thumb|300px| Putty settings]] | ||
Connect the USB-UART adapter. Open the session. | |||
Теперь при включении WirenBoard должна сразу выводиться консоль линукса при загрузке. | Теперь при включении WirenBoard должна сразу выводиться консоль линукса при загрузке. | ||
Версия 14:01, 19 июля 2019
Antenna connection
Connector u.fl for WiFi is inside the Wiren Board.
For connecting the antenna you need to remove the red charge, and a light press until it clicks to put the corresponding connector (it is convenient to do that with a pencil).
Antennas for GPS and GSM are connected from the outside of the board.
Do not place the GSM antenna near the processor. Aiming at the quartz of the processor causes it to reboot. Turn the antenna away from the USB and Ethernet connectors (as on the photo).
Flash card
Create a microSD card with the image.
Insert into the connector (on the side of the OLinuXino-MICRO Board).
Power Supply
Connect the external power supply to the power jack. Or supply power to terminals 17 (Vin) and 18 (GND). Permissible voltage range - 5-22 V.
Debug UART
See here .
For Windows users: download Putty and run it.
In the settings, specify the connection type - serial, speed - 115200, line - COM3 (usually COM3, otherwise see the device Manager list of ports).
Connect the USB-UART adapter. Open the session.
Теперь при включении WirenBoard должна сразу выводиться консоль линукса при загрузке.
Если этого не произошло, возможно вы перепутали Rx и Tx. Или по другой причине.