translator, wb_editors
4251
правка
Периферийные устройства с интерфейсом RS-485 серии WB-xxxx/en: различия между версиями
Периферийные устройства с интерфейсом RS-485 серии WB-xxxx/en (просмотреть исходный код)
Версия 15:22, 21 февраля 2023
, 1 год назадНет описания правки
(Новая страница: «== Device firmware update == Starting with the new firmware versions of the device, the firmware update functionality (firmware) via the Modbus Protocol is suppor…») |
Matveevrj (обсуждение | вклад) |
||
| (не показана 1 промежуточная версия 1 участника) | |||
| Строка 87: | Строка 87: | ||
{| class="wikitable" | {| class="wikitable" | ||
|[[Универсальный датчик WB-MS|WB-MSW v.1, v.2 hybrid sensors in wall-mounted enclosure]] | |[[Универсальный датчик WB-MS|WB-MSW v.1, v.2 hybrid sensors in wall-mounted enclosure]] | ||
| Строка 116: | Строка 115: | ||
|- | |- | ||
|[[WB-MD2_230V_Dimmer| | |[[WB-MD2_230V_Dimmer| | ||
LED and incandescent lamps dimmer WB-MD2] | LED and incandescent lamps dimmer WB-MD2]] | ||
|[[File:WB_MD2_small.png |100px]] | |[[File:WB_MD2_small.png |100px]] | ||
|- | |- | ||
|} | |} | ||
== How to install a new Modbus address on our RS-485 device== | == How to install a new Modbus address on our RS-485 device== | ||
# Connect the device to the controller, ONLY this device should be connected via the BUS. | # Connect the device to the controller, ONLY this device should be connected via the BUS. | ||
#: '''If you connect several devices on the bus, their performance will be disrupted!''' | #: '''If you connect several devices on the bus, their performance will be disrupted!''' | ||
# Run the [[ | # Run the [[SSH | console]] commands: | ||
<syntaxhighlight lang="bash"> | <syntaxhighlight lang="bash"> | ||
service wb-mqtt-serial stop # stop the standard RS-485 driver | service wb-mqtt-serial stop # stop the standard RS-485 driver | ||