ADC/en: различия между версиями
(Новая страница: «#Voltage must be within acceptable range. #Ax terminal blocks perform two functions: ADC and low voltage load control. Before measuring voltage, set the corresponding low voltage load control output to the "off" position. For example, if you are connecting to terminal A1, disable A1_OUT in the web interface (section Relays & FETs). #Connect your source to the terminal. The voltage value will immediately appear in the Wired Board Web Interface | web interfa...») |
(Новая страница: «== Input voltage ==») |
||
| Строка 7: | Строка 7: | ||
#Connect your source to the terminal. The voltage value will immediately appear in the [[Wired Board Web Interface | web interface]] on the ADCs. The value is also translated into the [[Special:MyLanguage/MQTT|MQTT]] message system. | #Connect your source to the terminal. The voltage value will immediately appear in the [[Wired Board Web Interface | web interface]] on the ADCs. The value is also translated into the [[Special:MyLanguage/MQTT|MQTT]] message system. | ||
Also, the value can be obtained in manual mode: [[Special:MyLanguage/Low-level work with ADC|Low-level work with ADC]]. | |||
== Input voltage == | |||
<div lang="ru" dir="ltr" class="mw-content-ltr"> | <div lang="ru" dir="ltr" class="mw-content-ltr"> | ||
Версия 19:42, 25 июля 2022
Как получить напряжение с АЦП
- Voltage must be within acceptable range.
- Ax terminal blocks perform two functions: ADC and low voltage load control. Before measuring voltage, set the corresponding low voltage load control output to the "off" position. For example, if you are connecting to terminal A1, disable A1_OUT in the web interface (section Relays & FETs).
- Connect your source to the terminal. The voltage value will immediately appear in the web interface on the ADCs. The value is also translated into the MQTT message system.
Also, the value can be obtained in manual mode: Low-level work with ADC.
Input voltage
Демон wb-homa-adc транслирует значение в очередь сообщений MQTT в топик /devices/wb-adc/controls/Vin . Таким образом, значение отображается в веб-интерфейсе как канал Vin устройства ADCs
Список АЦП для контроллера WB6
В Wiren Board 6 каналы АЦП процессора подключены к клеммникам A1-A4. Также на АЦП заведено входное напряжение (после входных диодов) и напряжение на клемме 5Vout.
Смотрите также: