12 063
правки
Hardware Watchdog Disable/en: различия между версиями
Нет описания правки
(Новая страница: «Hardware Watchdog Disable») |
|||
| (не показаны 3 промежуточные версии этого же участника) | |||
| Строка 2: | Строка 2: | ||
{{DISPLAYTITLE:Отключение аппаратного сторожевого таймера (watchdog)}} | {{DISPLAYTITLE:Отключение аппаратного сторожевого таймера (watchdog)}} | ||
Hardware [[Watchdog/en|Watchdog]] is sometimes required to be disabled: for example, if you want to turn off the controller completely (for example, on an event from an uninterruptible power supply); if the hardware watchdog will operate, the controller will resume operation after a while, even after the halt command. When the watchdog timer is disabled, the resumption of operation of the controller is possible only when you reset the power of the controller. | |||
To disconnect, you need to [[Разбираем корпус контроллера/en|disassemble the controller case]] and connect one of the on/OFF connector pins to the GND. | |||
{| class="wikitable" | {| class="wikitable" | ||
| Строка 11: | Строка 11: | ||
|} | |} | ||
The illustrations show which pins should be connected in the Wiren Board 5 and WirenBoard 6 controllers. The desired pin of the on/OFF connector is marked with a red arrow, the GND pins (you can use any of them) are marked with red circles. The purple line shows an example of a connection. | |||