Hardware Watchdog Disable/en: различия между версиями

Нет описания правки
(Новая страница: «To disconnect, you need to disassemble the controller case and connect one of the on/OFF connector p…»)
 
(не показана 1 промежуточная версия этого же участника)
Строка 2: Строка 2:


{{DISPLAYTITLE:Отключение аппаратного сторожевого таймера (watchdog)}}
{{DISPLAYTITLE:Отключение аппаратного сторожевого таймера (watchdog)}}
Hardware [[Special:MyLanguage/Watchdog|Watchdog]] is sometimes required to be disabled: for example, if you want to turn off the controller completely (for example, on an event from an uninterruptible power supply); if the hardware watchdog will operate, the controller will resume operation after a while, even after the halt command. When the watchdog timer is disabled, the resumption of operation of the controller is possible only when you reset the power of the controller.  
Hardware [[Watchdog/en|Watchdog]] is sometimes required to be disabled: for example, if you want to turn off the controller completely (for example, on an event from an uninterruptible power supply); if the hardware watchdog will operate, the controller will resume operation after a while, even after the halt command. When the watchdog timer is disabled, the resumption of operation of the controller is possible only when you reset the power of the controller.  


To disconnect, you need to [[Разбираем корпус контроллера/en|disassemble the controller case]] and connect one of the on/OFF connector pins to the GND.
To disconnect, you need to [[Разбираем корпус контроллера/en|disassemble the controller case]] and connect one of the on/OFF connector pins to the GND.
Строка 11: Строка 11:
|}
|}


На иллюстрациях показано, какие выводы необходимо соединить для этого в контроллерах Wiren Board 5 и WirenBoard 6. Нужный вывод разъема ON/OFF отмечен красной стрелкой, выводы GND (можно использовать любой) отмечены красными кружками. Фиолетовой линией показан пример соединения.
The illustrations show which pins should be connected in the Wiren Board 5 and WirenBoard 6 controllers. The desired pin of the on/OFF connector is marked with a red arrow, the GND pins (you can use any of them) are marked with red circles. The purple line shows an example of a connection.
12 063

правки